MONTAGUE 243W36 Spezifikationen PDF herunterladen (Seite 8)

SM-8

The MONTAGUE Company

4. Install the new pilot assembly, orifice and pilot

assembly bracket.

5. Connect the gas line to the back of pilot assembly.

NOTE: Make sure that the pipe joint compound or

pipe thread sealant that is being used is resistant

to the corrosive actions of liquefied petroleum gases.

6. Turn the main gas shutoff valve to the broiler to

the ON position.

WARNING

ALL GAS JOINTS DISTURBED DURING

SERVICING MUST BE CHECKED FOR LEAKS.

CHECK WITH A SOAP AND WATER SOLUTION

(BUBBLES). DO NOT USE AN OPEN FLAME.

7. Light pilot and adjust pilot valve.

8. Reinstall venturi cover, heat shield, insulation and

exterior top.

Figure 6. Pilot Assembly Connection

Figure 7. Pilot Assembly

MAIN BURNERS

The connection for the burners is accessed by removing

the venturi cover. The burners are accessed by

removing the grids and carriage. The burner valves are

accessed by removing the control panel cover.

CAUTION

Turn off the gas supply at the main shutoff

valve that is next to the broiler before

attempting to loosen any gas connections.

Burner Assembly, Orifice and Venturi

1. Remove the venturi cover as described in COVERS

AND PANELS.

2. Remove the ceramic radiants from each side of

the main burner to be replaced.

3. Loosen the set screw that attaches the main

burner to the venturi assembly.

4. Slide the main burner out of the broiler.

5. If the venturi or orifice is to be replaced, disconnect

the gas input to the venturi. Remove the gasket.

Replace the gasket every time the venturi or

burner is removed.

6. Loosen the lock nut so that the venturi can be

removed from the bracket.

Figure 8. Burner Pilot Assembly

7. Remove the orifice hex nut fitting from the venturi.

8. Remove the orifice from the hex nut fitting.

NOTE: Make sure that the pipe joint compound or

pipe thread sealant that is being used is resistant

to the corrosive actions of liquefied petroleum gases.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

MONTAGUE 243W36 Spezifikationen Seite 8

Kommentare zu diesen Handbüchern