MONTAGUE 243W36 Spezifikationen PDF herunterladen (Seite 6)

SM-6

The MONTAGUE Company

PARTS REMOVAL AND REPLACEMENT PROCEDURES

Perform the following procedures to remove and

replace parts. To eliminate mistakes when ordering

parts, always provide the following information:

• Model Number

• Serial Number

These numbers are located on the nameplate.

CAUTION

Turn off the broiler gas valve and allow broiler

to cool before removing any components.

COVERS AND PANELS

CAUTION

Turn off the gas supply at the manual shutoff

valve that is next to the broiler before

attempting to loosen any gas connections.

Venturi Cover

Removal of the venturi cover provides access to the air

shutter adjustments and main burner orifices.

1. Remove the two screws under the front edge of

the venturi cover.

2. Lift the venturi cover from the broiler.

Figure 1. Venturi Cover

Control Panel Cover

Removal of the control panel cover provides access to

the burner valves, pilot adjustment and carriage springs.

1. Turn the control valves to the full off position, then

remove the control valve knobs.

2. Remove the two screws from the front of the

control panel.

Figure 2. Control Panel Cover

DRIP DEFLECTOR

The drip deflector is located below the grid frame and

is angled toward the back of the broiler. Grease

dripping onto the drip deflector runs off the back edge

to the drip tray then flows forward into the horizontal

grease container.

1. Pull the grid frame assembly forward to the stop.

2. Remove the grids from the frame assembly.

3. Lift the back edge of the drip deflector to disengage

the drip deflector from the retaining latch.

4. Slide the drip deflector out at a downward angle.

5. When reinstalling the drip deflector, be sure to

engage the front end under the retaining latch.

Figure 3. Drip Deflector

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

MONTAGUE 243W36 Spezifikationen Seite 6

Kommentare zu diesen Handbüchern